2026 Catalog - Flipbook - Page 112
WIRE MESH SLINGS
Widely used in metalworking shops and steel warehouses where loads are abrasive, hot or
tend to cut web slings.
Features and Bene昀椀ts
Promotes Safety
•
•
Slings are repairable.
Wire mesh is galvanized to resist corrosion.
•
Steel construction resists abrasion and
cutting.
•
Each sling is permanently stamped with capacity
and serial number.
•
•
•
Grips contour of the load.
•
•
Each sling is proof-tested and certi昀椀ed.
•
Grips load 昀椀rmly without stretching - reduces load
damage.
•
Resists abrasion and cutting for greater sling
life.
•
Low stretch and wide-bearing area distributes
load to help avoid damage.
Alloy steel end 昀椀ttings are zinc plated for long
life.
Saves Time
Saves Money
Width of mesh helps control and balance load.
End 昀椀ttings accommodate most large crane
hooks.
Environmental Considerations
•
Wire mesh slings shall not be used at
temperatures above 550°F.
•
Store in a clean, dry area.
Roughneck Wire Mesh Sling Construction - 10 Gage Standard
Alloy steel end 昀椀ttings are zinc plated. Mesh is 10 gage galvanized high tensile steel (12 gage upon request).
Optional: Type 304 stainless steel mesh is available for use in corrosive environments.
HOW TO ORDER WIRE MESH SLINGS
Mesh
Slings
Rigging
Hardware
Chain
Slings
Wire
Rope
Sling
Protection
Round
Slings
Web
Slings
General
Information
Roughneck™ Mesh Slings
T1
10
X
10
Sling Length (ft.)
Use pull to pull length
Mesh Width (in.)
T1 – Type 1 (Triangle/Choker)
T2 – Type 2 (Triangle/Triangle)
Lifting
Devices
Plate
Clamps
Hoist
Rings
Lift-All
Hoists
Cargo
Control
6
Wire Gage Construction (10ga. or 12ga.)
Type 1
Type 2
Triangle
Choker
*
110
‘X’
WARNING
Triangle
Do not edge load. Full width of mesh must contact load.
Triangle
